Wood Flooring Tips
Wood Flooring Tips
When larger drops, the presence of protruding bulges base to align using, for example, nivelirmassy based dry mixes, strength, purity. On the basis should not be loose parts, various contaminants. Defects should be sure to remove, low humidity. According to the requirements of manufacturers of wood flooring moisture content should not exceed 2-3%. At higher humidity on the ground should be laid or a vapor barrier film (put overlapped), carefully connecting joints of special construction adhesive tape, or put on the base vlagozapirayuschuyu primer. The most widely used two methods of installation: Glue (fixation on the boards Based produced by gluing) and "floating". When laying method bonding base may be a concrete floor, cement and sand, plaster or other Magnezitovaya headband, lined if necessary Leveling-mass, with priming.Before gluing, be sure to measure the humidity of the base, it should be no more than 2,5-3% (producers of the floorboard, tend to give more specific recommendations). For check moisture content using a special device - hygrometer. The so-called "floating" floor is laid on two technologies: the adhesive and the castle. In the first case on the ridge and groove boards to apply the adhesive, and interconnect themselves. Click connection (in another terminology - clique) is performed without using glue. Currently used interlocking connection of the two species. In one case, the connection of boards produced by the principle "Turn and click, and the second hit-and-click." The most advanced types of locking connections do not require tools for assembly of parquet. The advantage of interlocking connections - high-speed assembly.
